Pacific A1 DDR4 RAM Water Block Pacific A1 DDR4 RAM Water Block Pacific A1 DDR4 RAM Water Block Pacific A1 DDR4 RAM Water Block Pacific A1 DDR4 RAM Water Block Pacific A1 DDR4 RAM Water Block Pacific A1 DDR4 RAM Water Block
Pacific A1 DDR4 RAM Water Block

Pacific A1 DDR4 RAM Water Block

재고 있음
P/N
CL-W239-CA00SW-A
USD$119.99

RAM Water Block with 4 sets of RAM heat sinks for two-way RAM heat dissipations.

Keep It Cool with Liquid Cooling

Thermaltake’s exclusive liquid cooling technology keeps the temperature of the RAM 37% lower than the RAM with only natural convection cooling. Pacific A1’s liquid cooling option ensures performance stability and longer lifespan of the RAM.

Cautions

Thermaltake recommends the following steps to be taken before using the Pacific series radiators and water blocks

  • To ensure a clean loop, flush and rinse your radiators and water blocks with distilled water prior to use.
  • Do not use tap water or distilled water as your coolant, it may harm your loop and reduce performance.
  • It is strongly recommended to use market proven pre-mix coolant, such as Thermaltake Coolant 1000. It offers great performance while protecting the entire liquid loop from corrosion.
  • Before storing your water cooling components, please clean, rinse and dry. This will ensure a longer lifespan for your components.

Thermaltake recommends the following steps to be taken after completing your water loop setup

  • It is strongly recommended to use market proven pre-mix coolant, such as Thermaltake Coolant 1000. It offers great performance while preventing the entire cooling system – copper, brass, nickel, aluminum, and steel – from corrosion.
  • Fill the reservoir with coolant and cycle the power on and off several times while the pump pushing the coolant into the loop.
  • DO NOT let the pump run dry, when there is no liquid entering the pump turn off your power immediately
  • Fill the reservoir to the top as it will prevent air from going into the pump
  • If necessary tilt the system slightly from side to side to bleed the air out of the loop.
  • Place some paper towels under fittings and joining points to test for leaks.
  • Run the loop with the fill port open for about 24 hours to completely bleed the air out of the loop.
  • Before starting, flush out your system correctly to prevent any coolant or unwanted particles sticking to your tubes, radiators and other cooling components.
  • Coolant might fade over time.
추가 정보
P/N CL-W239-CA00SW-A
Dimensions 53.8 x 37 x 133.8 mm
Connector 1 x Memory Water Block
4 x Memory Heat Sink Modules
1 x Controller
Compatibility DDR3、DDR4
(CPU Socket)